INSTALLATION INSTRUCTIONS
Wooden Vanity & Pre-Cut Marble Top
1147083-2-
B
2 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
THANK YOU FOR CHOOSING KALLISTA
We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
BEFORE YOU BEGIN
These instructions are for installing the wooden vanity cabinet (P73064) and pre-cut marble vanity top
(P73065).
Observe all local plumbing and building codes.
Prior to installation, unpack the new vanity and marble top and inspect them for damage. Return the vanity
and marble top to their protective cartons until you are ready to install them.
Refer to the vanity speci
fi
cation sheet for P-trap and supply location recommendations. Verify your supply
valves and P-trap will not interfere with the shelves and drawer. Install the water supply and drain lines. The
water supply nipples must extend 3
″
(76 mm) beyond the
fi
nished wall material.
These instructions cover installation to wood frame construction. For installation to other materials, supply
suitable bracing and fastening devices of suf
fi
cient size and strength.
Provide 2x6 backing material in the
fi
nished wall. The height from the top of the 2x6 backing material to the
fl
oor must be 36-1/4
″
(921 mm).
This installation is recommended to be done with a minimum of two people.
All dimensions given assume that the
fl
oor and walls are square, plumb, and level. Make appropriate
adjustments for other conditions.
Remove any moldings that may inhibit the vanity from being
fl
ush against the
fi
nished wall.
Make sure the path of the doors will not be obstructed as they swing open.
KALLISTA reserves the right to make revisions in the design of products without notice, as speci
fi
ed in the
Price Book.
TOOLS AND MATERIALS
• Conventional woodworking
tools and materials, as
appropriate
• Hole saw
• Wood screws
• Screwdriver
Plus
File
Clear 100% Silicone
Sealant or Caulk
Hex Wrench
Drill
Level
Pencil
Tape Measure
Safety Glasses
Hammer
