Tools
Important Information
CAUTION: Risk of personal injury.
Do not use the bath
filler as a grab bar or support bar when entering or exiting
the bath. The bath filler is not designed to support weight.
NOTICE:
Adequate floor support is required. The wood support
must be a minimum of 2” (51 mm) thick by 6” (152 mm) wide. 2x6
lumber is NOT adequate for this application.
NOTICE:
To avoid damage to the O-rings on the bottom of the
faucet, keep the faucet vertical and use care when installing the
faucet.
Observe all local plumbing and building codes.
Shut off the main water supply.
A drill bit is provided for installation to wood support. A
different drill bit is required for concrete floor installations; this
bit is not provided.
The dimensions given assume the spout and bath are mounted on
the same surface. Adjust the dimensions accordingly if the spout
and bath are mounted on different surfaces.
If this product is installed with an overflowing bath, the outer rim
of the bath should slightly overlap the 2x4 framing.
Installer-supplied copper tubing must be 5/8
″
OD (1/2
″
nominal).
Carefully review this document and any appropriate Roughing-in
documents. Design the bath enclosure accordingly.
The appearance of your faucet may differ from the illustrations in
this guide. The instructions still apply.
Sealant Tape
Pencil
Phillips Screwdriver
Tape Measure
Level
Drill
1156618-2-B
2
Kallista
