1085231-2-A
Page 3 of 3
P23010
Floor Riser Support Assembly
INSTALLATION INSTRUCTIONS
4. COMPLETE THE INSTALLATION
Questions? Problems? For additional assistance, please contact Kallista's Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
Slide the mounting plate so that it is flat against the side of
the bathtub, making sure the holes in the mounting plate line
up with the pilot holes in the bathtub.
Attach the mounting plate to the bathtub with the self tapping
screws.
Tighten the set screw in the tee bracket.
Mounting Plate
Self Tapping Screws
Tee Bracket
Set Screw
Cushion
Tee Bracket
Mounting Plate
Connecting Rod
Rotate the tee bracket toward the floor slightly.
Insert the cut end of the connecting rod into the tee bracket.
Rotate the connecting rod and tee bracket back up so that the
connecting rod is level.
Slide the mounting plate so that it is touching the side of the
bathtub.
Mark the location of the holes in the mounting plate.
Slide the mounting plate out of the way. Drill 1/8” dia x 5/8”
deep pilot holes, being sure that they are perpendicular to the
side of the tub.
WARNING: To avoid damaging the tub, do not drill
the holes deeper than 5/8”.
Apply a dab of silicone to the back of the cushion and position
it on the tub, centered between the three pilot holes.
Adjust the connecting rod so that the cushion is pinched
between the connecting rod and the bathtub.
Mounting Plate
Connecting Rod
Assemble the connecting rod and mounting plate.
