INSTALLATION INSTRUCTIONS
Basin Set
1133090-2-E
3 of 6
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
1. INSTALL THE SPOUT AND HANDLES
Spout
Shank
Washer
Rubber
Washer
Gasket
Nut
Handle
Assembly
Valve
Assembly
Tee
Assembly
Washer
Ring
Screws
P22731 Only
Gaskets
Check
Valve
Check
Valve
Rubber
Washers
Install the Spout
Remove the tee assembly, nut, and washer from the spout shank.
Ensure that the O-ring is installed to the underside of the spout.
Fit the spout shank through the top of the lavatory.
Install the washer and nut onto the spout shank. Securely wrench tighten the nut.
Insert the rubber washer and gasket into the tee. Thread the tee onto the spout shank.
Hold the spout in position and tighten the tee securely. Do not overtighten.
For P22731 only: Install the rubber washers, gaskets, and check valves onto the tee assembly.
If desired, apply a bead of silicone sealant or caulk around the base of the spout.
Install the Handle Assemblies
Partially thread the screws into the ring.
Ensure that the O-ring is installed to the underside of the COLD handle assembly.
Fit the valve assembly through the top of the lavatory.
Install the washer and ring onto the valve assembly. Thread the ring most of the way up the valve assembly.
Tighten the screws. Do not overtighten.
If desired, apply a bead of silicone sealant or caulk around the base of the handle assembly.
Repeat the procedure to install the HOT handle assembly.
