INSTALLATION INSTRUCTIONS
Inigo Console Table
1095725-2-A
Page 3 of 5
Questions? Problems? For additional assistance, please contact Kallista’s Customer
Service Department at 1-888-4KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
PRePARe THe SITe
1.
Finished
Floor
Wall Bracing
(2x6 minimum)
CL
Finished
Wall
Mark the
anchor
holes.
Side Rail
Bracket Anchor
Holes
Console Table
Bracket Anchor
Holes
Foot
Anchor
Holes
21-1/4”
16”
CL
26-23/32”
31-13/16”
31-1/2”
32-13/16”
34”
Rough-in the water supply lines and the drain piping.
Install a minimum of a 2x6 as a wall brace to provide support for
the wall bracket. The brace should be the same length as the
console table, 36″ and should be positioned 32″ from the finished
floor to the top edge of the board. The center of the wall brace
should be in-line with the drain outlet.
Finish the wall.
Mark the centerline on the floor and the wall.
Mark the anchor holes on the wall for the side rail mounting
brackets.
Mark the anchor holes for the console table mounting bracket on
the wall by holding the bracket up to the finished wall so that the
center of the bracket lines up with the centerline. Mark the loca
-
tion of the anchor holes with a pencil.
Mark the location of the holes on the floor for the feet anchors.
Drill two holes 5/16″ D. x 1/2″ deep, in the finished floor for each
foot anchor. The holes should be 21-1/4” from the wall and 16”
from the centerline.
INSTALL THe MOUNTING BRACKeTS
2.
Console Table
Mounting Bracket
Side Rail
Mounting Bracket
Install the side rail mounting brackets to the finished wall
with fasteners suitable for your wall type.
Install the console table mounting bracket to the finished
wall with fasteners suitable for your wall type.
Verify the table mounting bracket is level.
