17
1.
By pressing
P
until the icon for
thermostat
or manual mode
begin to flash.
2.
Press
P
again to selec the icon of
your choice.
3.
Briefly press
to exit the menu.
4.8 Setting the flame intensity by
thermostat
The remote control measures the
temperature and the flame intensity is
modulated accordingly. To ensure an
accurate temperature reading, make
sure the remote control is outside of
the fire’s radiation range.
1.
Select the thermostat programme
as indicated in paragraph Selecting
the thermostat or manual operating
programme on page 17.
2.
Press the button with the
+
or
with the
so that the temperature
indicator on the display starts to
flash.
3.
Set the desired temperature with the
+
and
buttons.
4.
Wait for 10 seconds before using
the remote control to save the set
temperature.
4.6 Setting the flame intensity
The height of the flames can be
adjusted from high to low and is
indicated on the display by numbers 1
through 8. The flame intensity can also
be displayed by the flame intensity
indicator.
The ECO mode has a modulating effect
on flame intensity (higher or lower).
This accentuates the visual effect
and user comfort of the flames, while
reducing the fire’s heat emission and
gas consumption by approximately
40%. Use the remote control to set the
flame intensity in “ECO mode” to 9,
after which the double flame icon will
display on the screen. Adjust the flame
intensity as follows:
1.
Press
+
or
to adjust flame intensity.
2.
Release the
+
or
button.
3.
Press the
+
button until the number 9
appears to switch on the ECO mode.
4.7 Selecting the thermostat or
manual operating programme
The flame intensity and the resulting
room temperature can be adjusted by
setting the remote control in manual
or thermostat mode. To ensure an
accurate temperature reading, make
sure the remote control is outside of
the fire’s radiation range. For security
reasons, the thermostat mode will be
automatically switched off after 24
hours. If the flames in the gas fire have
been switched off, the programme will
restart in manual mode automatically
when next switched on.
