Pan/Tilt/Zoom Receiver Programming
2
1035406B / January 2002
For Technical Support and Sales call 800-469-1676
4)
Supply power to the receiver.
5)
Wait 5 seconds.
6)
Place the receiver in normal mode (see Figures 3 and 4).
KTD-128 receiver card
KTD-125C receiver card
Figure 3. Placing the KTD-125B in normal mode
Figure 4. Placing the KTD-128 and KTD-125C in normal mode
To change mode-of-operation choices, repeat steps 1 through 5.
Note:
When reentering programming mode, all mode-of-operation choices must be reprogrammed, even if only one is being
changed.
A
SSIGNING A
S
ITE
A
DDRESS
CAUTION:
Make sure the receiver is in normal operating mode before changing DIP switches 1 through 9 for site
addressing.
To assign a site address, see Table 2 and perform the following:
1)
Place the receiver in normal mode (see Figures 3 and 4).
2)
Determine which DIP switch values must be added together to equal the site number.
3)
Place the DIP switches that correspond to those values in the ON position.
Note:
You can assign a site address while power is supplied to the unit.
Table 2. Site address values
DIP Switch
1 2 3 4 5 6 7 8 9
Value
1 2 4 8 16 32 64 128 256
