Pan/Tilt/Zoom Receiver Programming
For Technical Support and Sales call 800-469-1676
1035406B / January 2002
1
A Kalatel pan/tilt/zoom receiver has several mode-of-operation choices that you must program for the
receiver to function as desired. Typically, the receiver is programmed with a Kalatel controller keypad, but
it can also be programmed manually, as described in these installation instructions.
P
ROGRAMMING THE
R
ECEIVER
1)
Disconnect power from the receiver.
2)
Place the receiver in programming mode (see Figures 1 and 2).
KTD-128 receiver card
KTD-125C receiver card
Figure 1. Placing the KTD-125B in programming mode
Figure 2. Placing the KTD-128 and KTD-125C in programming
mode
3)
Set DIP switches for the desired mode of operation (see Table 1).
Table 1. Setting DIP switches for the desired mode of operation
DIP Switch 1
Zoom Polarity
1=OFF
Zoom in positive, zoom out negative
1=ON
Zoom in negative, zoom out positive
DIP Switch 2
Iris Polarity
2=OFF
Iris open positive, iris close negative
2=ON
Iris open negative, iris close positive
DIP Switch 3
Pan/Tilt Drive
3=OFF
Not DC motors
3=ON
DC motors
4=OFF 5=OFF
Normal
4=ON 5=OFF
50% duty cycle
DIP Switches 4 and 5
Autopan*
4=OFF 5=ON
Random pan
4=ON 5=ON
Disable autopan
DIP Switch 6
Autopan on Power-Up
6=OFF
Yes
6=ON
No
DIP Switch 7
Zoom Lens Voltage
7=OFF
12 VDC
7=ON
6 VDC
DIP Switch 8
Invert Up and Down Tilt
8=OFF
Not inverted
8=ON
Inverted
*The KTD-128 does not have an autopan function.
