NetID: the network no. of the two PLC. The network no. must be same for the same network, here it is
set to 1.
StationID: every PLC station no. in the network. In this network, the two PLC station no. is 1 and 2.
Net type: please select TBN for PLC communication, OMMS or TBN is for communication between
HMI and PLC. OMMS is also suitable for communication between PLC and servo.
Baud rate: for this application 1.5M
Token cycle time: each station cycle once in the same network, the unit is ms. For this application,
there are only two PLC, so we set it to 10ms.
Max station number: the max station numbers in the network. X-NET max station no. cannot over 32.
6. click write config, it will show write config successful.
7. click confirm, cut off the PLC power supply, then power on again. Now the configuration is effective.
8. click config/single device/route.
9. it will show below window.
10. click the additem, it will show the configuration window.
Summary of Contents for XINJE XD series
Page 1: ...XD series BD board...
