- 9 -
Safety Precautions
PLEASE READ
all instructions before installing, operating, or servicing the appliance.
Danger and Warning:
Failure to follow this safety statement will result in severe personal injury or death,
property or equipment damage.
RISK OF CHILD ENTRAPMENT.
Before you throw away your old refrigerator or freezer, take off the doors and
leave shelves in place so children may not easily climb inside.
SHOCK HAZARD
- Electrical Grounding required.
Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected.
Never remove the round grounding prong from the plug and never use a two-prong grounding adaptor.
Altering, cutting of power cord, removal of power cord, removal of power plug, or direct wiring can cause
serious injury, fire or loss of property and life, and will void the warranty.
Never use an extension cord to connect power to the unit.
Always keep the working area dry.
Important Precautions
Do not lift unit by door handle.
Do keep the door closed before installing into cabinet.
Be sure the kick-plate on the front bottom is free from obstruction. Obstructing free airflow can cause the unit to
malfunction and will void the warranty.
Failure to clean the condenser every six months can cause the unit to malfunction.
Allow unit temperature to stabilize for 24 hours before use.
Do not block any internal fans.
Use only genuine supplier's replacement parts. Imitation parts can damage the unit, affect its operation or
performance and may void the warranty.
Installation Instructions
Before using your wine cooler:
Remove the exterior and interior packing
Before connecting the appliance to the power outlet, let it stand upright for approximately 2
hours. This will reduce the possibility of malfunction in the cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Place your appliance on a floor that is strong enough to support the appliance when it is fully loaded.
To level your appliance, adjust the front legs at the bottom of the appliance.
To install the door handle:
For shipment, the door handle has been stored inside of the unit binding to the wood shelves. To install the
handle, the door gasket should be gently pulled back where it covers the screw holes for the handle, then the
handle should be attached by screwing into place with the two screws which are packed in the box with this
Instruction Manual and other spare parts.
To reduce the risk of fire, electrical shock, or injury when using your
appliance, follows these basic precautions;
Summary of Contents for KRC-18SZB
Page 11: ...11 KRC 30SZB KRC 46DZB...