Basic Controls
K10WBT
10” abrasive wheel, 5/8” arbor, LH thd.
Coolant tank & pump @ 110 volt, control voltage is 24v.
Manual pull down.
1. 5/8”arbor, Left hand spindle nut. Use the correct abrasive wheel for the
material being cut. Burned or discolored parts indicate the WRONG abrasive
wheel. Consult your dealer for the correct wheel grade.
2. Coolant- On/Off, controls coolant flow. Close for more pressure on washout
hose.
Use a rust inhibiting coolant. DO NOT USE STRAIGHT WATER! CONSULT
YOUR DEALER FOR COOLANT SPECIFICATIONS. A GOOD
GRINDING COOLANT SHOULD WORK.
3. Washout hose- Close valve when cutting. Clean out- Open valve, rotate
selector switch #4 to “pump” ( only pump runs, not blade). Close valve when
machine is washed out. Leave cabinet doors open to dry out the cabinet.
4. Selector switch- Choose “Saw” or “pump”. “Saw” position runs saw blade
AND coolant pump. “pump” position runs just the coolant pump for wash out.
5. STOP- Push in to STOP. Pull out selector to re-set STOP.
6. Light- On/Off. 24 v halogen bulb # 457-002.
7. T-Slot table- Use T nuts to hold vises, clamps, etc.
8. Vises- Vises can be slid forward/backward for part positioning. Always cut
ahead of wheel center on the front side of the abrasive wheel.
9. Electrical- Input line voltage into L1,L2,L3 on the contactor. Be sure
incoming voltage matches machine set-up. IF NOT FAMILIAR WITH
ELECTRICS CONSULT AN ELECTRICIAN. ELECTRICAL FAILURES
DUE TO INCORRECT WIRING ARE NOT WARRANTED.
10. Spindle lock- Use 3/8” rod to lock spindle to remove spindle nut ( LH
thread).
Maintenance- Keep machine cleaned out with the wash down hose. Leave
cabinet doors open to dry out the machine after clean out. Always follow safety
procedures. ( see safety sheet).
Summary of Contents for K10WBT
Page 1: ...K10WBT METALLURGICAL SAW MANUAL MADE IN USA...
Page 3: ......
