Kalamazoo K-CKTPD-3-NA-LPBLK, Use And Care Manual

Page: 12 / 18

+1.800.868.1699 21 KalamazooGourmet.com 20
Initial Assembly
You will need a ¾” wrench and a ½” wrench for initial assembly. Reference Figure 12 for Double
Burner Cooktop. Referrence Figure 13 for Double Burner Cooktop with Power Wok Burner.
A.
Set BASE UNIT A onto a level
surface.
B. Natural Gas and Bulk LP units
include a 10 ft (3 m) gray bulk gas
hose with a quick-disconnect. Using
the two wrenches tighten gas hose
to 3/8” male flare fitting at rear of
BASE UNIT A.
C. LP units, for use with 20# (9 kg)
gas tank, include a 6 ft (1.8 m)
black lp gas hose with a dual-stage
LP regulator C. Using the two
wrenches tighten gas hose to 3/8”
male flare fitting at rear of BASE
UNIT A.
D. After the unit has been installed, set
the black DIFFUSER CAPS D down
onto each side burner. Set the black
WOK BURNER DIFFUSER CAPS D2
down onto the wok side burner.
E.
Set the SIDE BURNER GRATE E/E2
down, so that it is nested in burner
well. For Wok Burner units, make sure
that the grate circles are oriented to
the front, over the wok burner.
F. Place SIDE BURNER COVER F over
assembled Side Burner Unit.
WARNING:
Never operate the side
burners with the cover in place.
G.
Mount CONTROL KNOBS G onto
the valve posts. Be sure that the
flat side of the opening in the knob
casting is aligned with the flat side
of the valve stem.
H. LIGHTING INSTRUCTIONS/must be
pushed back underneath cooktop
when not in use. DO NOT OPERATE
BURNERS WITH INSTRUCTION
PLATE PULLED FORWARD. Push
closed until opening under control
panel is completely unobstructed.
H
F
E
D
A
F
B
C
G
FIGURE 12
Double Burner Cooktop
F
E2
D
A
B
C
G
FIGURE 13
Double Burner Cooktop with Power Wok Burner
D2
H