6
OPERATING YOUR FRIDGE/FREEZER
POWER REQUIREMENTS
The Fridge/Freezer is designed to operate on
AC or DC voltage.
AC input 110-120V AC at 60Hz to AC adaptor
(e.g. electrical power point)
DC input 12V or 24V DC (e.g. car cigarette
lighter or car battery)
If the Fridge/Freezer is operating when the
vehicle ignition is switched OFF, the Fridge/
Freezer will switch OFF automatically unless
vehicle is fitted with dual battery system.
The Fridge/Freezer will automatically switch
back ON when the vehicle is re-started and
the power source voltage reaches the Battery
Monitor cut-in setting.
OPERATING WITH 12/24V DC
Plug the 12V/24V DC power cable into the
DC POWER socket (Fig 3.) on the end of the
Fridge/Freezer and then connect to the vehicle
cigarette lighter socket or suitable 12V or 24V
DC power source.
The Fridge/Freezer will automatically turn
on, there is no requirement to switch the
appliance on.
The display will automatically show the current
internal cabinet temperature.
For optimum performance and efficiency, it is
important that the Fridge/Freezer has a reliable
DC power source available. Direct connection
to the battery is recommended and reduces
the risk of voltage dropping too low for the
appliance.
Use only the DC power cable supplied with the
Fridge/Freezer.
I
mportant:
If a DC extension cable is required
we recommended use of a AWG11 Twin
Sheath Two Core cable with direct connection
to the positive and negative battery terminals
with 15A inline fuse protection.
12/24V DC Power Requirements
If your Fridge/Freezer is cutting out prematurely, it
could be due to:
1. The battery voltage protection being set
too high on the Battery Monitor (refer to page
9/10).
2. DC power cable and/or connections are not
suitable to carry the required current. Check
the power cable and all connections and
adjust the Battery Monitor on the control panel
if required.
The Fridge/Freezer is equipped with a
multilevel Battery Monitor that protects your
vehicle battery against excessive discharging
when the Fridge/Freezer is connected to 12V
or 24V DC power source.
Important:
When using the Fridge/Freezer
with DC power supply, we recommend setting
the Battery Monitor to LOW if Fridge/Freezer
not running off crank battery.
NOTE:
A battery charger may only be
connected to the battery when the Fridge/
Freezer has been disconnected from the DC
power source.
Re-connect fridge after charger has been
connected.Over-voltage may cause damage to
the electronics of the Fridge/Freezer.
Your Fridge/Freezer is equipped with reverse
polarity protection. It protects your Fridge/
Freezer against reverse battery connection and
short circuit.
As a protection for your battery, the Fridge/
Freezer switches OFF automatically if the
power source voltage is insufficient. Fridge will
only restart when voltage reaches cut in level.
NOTE:
It is important that the correct cable
size and gauge is used for the installation of
the DC supply as over distance the voltage
can decrease if the incorrect cable size and
gauge cable is being used.
Always consult a qualified automotive
electrician when using a DC extension cable.
