KAKA Industrial BTM250, Operation Manual

Page: 3 / 17

3
General Specifications
General Machinery Cautions
- Misuse of this machine can cause serious injury.
- For safety, the machine must be set up, used and
serviced properly.
- Read, understand and follow the instructions in the
operator’s and parts manual which was shipped with your
machine.
When setting up the machine:
- Always avoid using the machine in damp or poorly
lighted work areas.
- Always be sure the machine is securely anchored to the
floor.
- Always keep the machine guards in place.
Always put the start switch in the “OFF” position before
plugging in the machine.
When using the machine:
- Never operate the machine with safety guards missing.
- Always wear safety glasses with side shields (See ANSI
Z87.1)
- Never wear loose clothing or jewelry.
- Never overreach — you may slip and fall into the
machine.
- Never leave the machine running while unattended.
- Always shut the machine off when not in use.
When servicing the machine:
- Always unplug the machine from the electrical power
while servicing.
- Always follow the instructions in the operators and parts
manual when changing accessory tools or parts.
You — the stationary power tool user — hold the key to
safety.
Read and follow these simple rules for best results and full
benefits from your machine. Used properly, the machinery
is among the best in design and safety. However, any
machine used improperly can be rendered inefficient and
unsafe. It is absolutely mandatory that those who use our
products be properly trained in how to use them correctly.
They should read and understand the Operators and
Parts Manual as well as all labels affixed to the machine.
Failure in following all of these warnings can cause
serious injuries.
General Machinery Warnings
1. Always wear protective eye wear when operating
machinery. Eye wear shall be impact resistant, protective
safety glasses with side shields which comply with ANSI
Z87.1 specifications. Use of eye wear which does not
comply with ANSI Z87.1 specifications could result in
severe injury from the breakage of the eye protection.
2. Wear proper apparel. No loose clothing or jewelry
which can get caught in moving parts. Rubber soled,
nonslip, footwear is recommended for best footing.
3. Do not overreach. Failure to maintain a proper working
position can cause you to fall into the machine or cause
your clothing to get caught — pulling you into the
machine.
4. Keep the guards in place and in proper working order.
Do not operate the machine with the guards removed.
5. Avoid dangerous working environments. Do not use
stationary machine tools in wet or damp locations. Keep
work areas clean and well lit.
6. Special electrical precautions should be taken when
working on flammable materials.
7. Avoid accidental starts by being sure that the start
switch is in the “OFF” position before plugging in the
machine.
8. Never leave the machine running while unattended.
The machine shall be shut off whenever it is not being
Table size Disc:12x16 3/8 in. (254x416mm)
Belt: 7 3/8x14 3/4 in. (187x355mm)
Table tilt (both) 45° down, 20° up
Miter gauge groove
(both) 3/8x3/4 in. (9.5x19mm)
Disc diameter 12 in. (305mm)
Disc Speed 1960 RPM
Platen size 6 1/4x14 3/4 in. (159x375mm)
Belt size 6x48 in. (152x1214mm)
Belt speed 2850 SFM
Dimensions w/platen 19x16x57 1/2 in.
vertical (depth,W, H) (475x400x1437mm)
Dimensions w/platen 25 1/2x16x43 in.
horizontal (depth, W, H) (637x400x1075mm)
Weight
90Kg