23
. OUTPUT
:
(23)
Provide for connection of external 4ohms speaker cabinet.
NOTE: The way connect with speaker
(1)
Connect two speakers at same time, The impedance of each speaker must 8ohms
(2)
If you only connect one speaker, please connect according to the impedance.
24. HEADPHONE
:
(24)
There is emulator of speaker embedded into amp, so when you practice in home, you can only connect amp with headphone, don’t
need connect cabinet again. Even you don’t need buy expensive cabinet.
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
POWER AMPLIFIER SECTION
6L6 (EL34)’s with 12AX7 driver
Rated Power &Load
5w RMS into 8, 4 ohms
Power @Clipping (Typically)
(5%THD, 1 KHZ, 120v AC line) 5W RMS into 8, 4 ohms (Bias must be reduced to measure)
Frequency Response:
+0,-2db, 50HZ to 15KHZ,@, 20w RMS into 16 ohms
Hum &Noise:
Greater than 80 dB below rated power
Power consumption:
70 wtts
，
50/60HZ. 120 VAC (domestic)
PREAMP SECTION
2-12AX7’s
The following specs are measured @1KHz with the controls present as follows:
Pre &Post (lead)@0
Reverb Level @0
Bass &Treble EQ @12
Middle
EQ@0
Boost Switch Out
