Connection Scheme :
TECHNICAL DATA:
Rated Voltage (Un)
: 220 VAC
Operating Range
: (0.8 – 1.1)xUn
Frequency
: 50 Hz
Supply Power Consumption
: < 4 VA
Measurement Sensitivity
: 1%
+
digit
Display
: Two lines of 3 Digits LED display
Motor Driver Output
: 12 – 15 Vac
Contact Current
: Max. 5A / 240 Vac
Device Protection Class
: IP20
Connector Protection Class
: IP00
Temperature
: -5°C....+50°C
Humidity
: 15% ...... 95% (without condensation)
Connection Type
: To front panel tap
Dimensions
: 72x72x80 mm
Warning !!!
- The message Er1 or Er2 on the screen means that the device has got
a failure
- Clean the device using dry dustcloth after de-energizing the device
t
Output voltage
SET value
Normal range
where the engine
is not operated
Speed zone
access
V
Max. Speed zone
Access to Output Voltage:
± Normal
range value
± Normal
range value
± Speed control zone
± Speed control zone
Max. Speed zone
Speed zone
access
SET
Increase
Decrease
SET
SET
Increase
Decrease
Press SET button untill SEt
shows up on the screen
.
SET
Increase
Decrease
SET
Increase
Decrease
SET
SET
Increase
Decrease
SET
Increase
Decrease
SET
Increase
Decrease
SET
Increase
Decrease
SET
Increase
Decrease
SET
EXIT
SET
SET
Increase
Decrease
Motor or Device
Connection Fault
000 : Fault Control Off
001 : Fault Control On
Output voltage
SET value
(80 – 400 V)
± Normal range value
(0,1 – 10 V)
defines the non-motorized
zone.
example :: 0.5
220 + 0.5 = 220.5 V
220 - 0.5 = 219.5 V
Speed (motor speed)
SET value (1 – 5 )
Set motor speed to ensure
smooth transition.
min speed = 1
Openning Time
SET value (0,01 – 60 sec)
This time counts for opening
when excessive or lower
limit is reached.
± Speed control zone
(0,1 – 10 V)
Slow motor speed region
determined to provide soft
transition to setpoint
Exit
% Under voltage
SET value
(0,05 -0,50)
220 x (1-0.26) = 163 V
Closing Time
SET value (0,01 – 60 sec)
At the end of this time the
output is released when
the voltage returns to the
normal value.
% Over voltage SET value
(0,05 -0,50)
220 x (1+0,12) = 246 V
SET
Increase
Decrease
Engine Power Balance
(30 – 140 )
It helps to find the ideal power usage of different motors.
For non-impact operation
SET
Increase
Decrease
%Output Overvoltage
SET value
(0,05 -0,50)
220 x (1+0,12) = 246 V
SET
Increase
Decrease
%Output Under voltage
SET value
(0,05 -0,50)
220 x (1-0.26) = 163 V
L1
N
Output Contact
5A / 240Vac
V
in
V
out
V
out
N
SW1 SW2 Vac
12-15
VARIAC
(Variable
Transformer)
12V
DC
motor
3Ω 11W
0
12V
Auxiliary supply
% Hysteresis value for
Openning- Closing
Overvoltage;
246 x (1-0.01)=244V
Undervoltage;
163 x (1-0.01)=161V