↻
Cardboard packaging with mount and mounting kit removed from the packaging and opened.
1. Mark the mounting position on the wall surface according to the position of the mount by drawing a line.
2. Mark the positions of the drill holes using the slot in the mount.
.
NOTE: The minimum clearances between two devices, or the device and the ceiling/floor have already
been taken into account in the diagram.
3. Fix the mount to the wall using suitable mounting fixtures from the mounting kit.
.
NOTE: Make sure that the mount is oriented correctly.
ð
Proceed with the installation of the device.
6.4
Installing and securing the device
CAUTION
Risk of injury from improper lifting and transport.
Lifting the device improperly can cause the device to topple and fall over.
1. Only ever raise the device vertically using the openings provided.
2. Use a climbing aid for the chosen installation height.
3. Wear safety gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may go into power regulation mode
due to insufficient ventilation and the resulting heat build-up.
1. Observe the minimum clearances and provide for sufficient heat dissipation.
2. Any objects on the housing of the device must be removed prior to operation.
3. Make sure that foreign objects cannot hinder heat dissipation following installation of the device.
1
2
3
Fig. 18:
Lifting the device by the opening
4
3
Fig. 19:
Fitting the device onto the mount
Legend
1
Opening
3
Mounting bracket
2
Center of gravity
4
Mount
Lifting and mounting the device
↻
The mount has been installed.
Manual
Assembly and preparation | 6
KACO blueplanet 110 TL3 KACO blueplanet 125 TL3
Page 19
EN-US
