step 2
Hardware included
A
Things you need to know
• Always read the instructions first before installation
• Not suitable for outdoor
• Cut off the power source during the installation
• Don’t bend the cables
• Keep proper ventilation around the unit and don’t stack any
object on it.
• Keep 10-15 cm of clearance when the device is close to a heat
source
• Please consider the total wattage of all lights being joined
together and select the LED Driver that is greater than this total,
taking the following into consideration:
• 15w = max load 13.5w
• 30w = max load 27w
• 75w = max load 67.5w
• Never fully load the circuit. Max load = 21.6W
• If you have any questions, contact us on:
Australia:
1800 666 078
Monday to Friday between
8:00am and 6:00pm AEST, New Zealand:
0800 522 663
Monday to Friday between 8:00am and 5:00pm NZST
or email:
.
Plastic IR Control
addition
installation guide
p.
1
Ver. 1
W-50563
Follow these
instructions to
build and attach
your IR Control
Switch with cable
12VDC
IR control switch with cable 12VDC
B
3M Sticker
If you are using an
IR Control Switch with
the 15W or 30W Driver & Distributor
, the
IR Control Switch can be connected in
between the Driver, and the Distributor.
1.
Separate the connector between the
Voltage LED Driver
and the distributor
2.
Connect IR Control Switch to
connectors at end of the Driver and
the Distributor.
3.
Insert extension cable from LED panel
into Distributor
4. Connect Driver to power source
If you are using an
IR Control Switch
with
the
75W Driver,
the Distributor cannot be
separated.
1.
Connect IR Control Switch directly to
the Distributor.
2.
Insert extension cable from LED panel
into end of IR Control Switch
3.
Connect Driver to power source.
11
11
22
22
33
33
Voltage LED
Driver
Voltage LED
Driver
IR Control Switch
with Cable
Distributor
Distributor
4
