11
1. Change Master Code and place lock in Passage Mode.
STEP 1.
Enter
#
to Start the Programming Mode
STEP 2
.
Enter the 8-Digit Factory Default Master Code:
1 2 3 4 5 6 7 8 #
STEP 3.
Enter Change Master Code Code Command:
0 0 0 #
STEP 4.
Enter New 8-Digit Master Code:
8 7 6 5 4 3 2 1 #
STEP 5.
Reenter New Master Code to Confirm:
8 7 6 5 4 3 2 1 #
STEP 6.
Enter Code Command:
399 # 1 #
to Activate Passage
STEP 7.
Enter
#
to Exit Programming
2. With a Phillips Head screwdriver, remove and retain the Cylinder
Locking Screw (54746) that secures the factory installed cylinder
into the housing.
(Fig’s. 6, 7, and ,8)
3. Remove the existing cylinder from the housing assembly.
Tip: You can insert the key half way into the key way and use it as
a tool to aid in rotating the cylinder out far enough to remove it by
hand.
4. Inside the cylinder hole of the housing, ensure the Key Override
Cam is positioned clear
(Fig’s 9 & 10)
.
Ensure that the Key
Override Cam is completely
out of the opening, as
shown, so that the key
cylinder will be able to be
correctly assembled.
Key Override Cam
C-3
Changing the Key Cylinder:
A standard, factory installed cylinder (54450) has been provided with the
E-Plex 3000. To change/replace the cylinder, carefully follow the steps
below.
Cylinder Locking
Screw Access
Hole
Figure 6
Figure 7
Figure 8
Cylinder Locking Screw
(54746) as assembled
Removed Cylinder
Locking Screw (54746)
Figure 9
Figure 10
Summary of Contents for E-PLEX 3X00 SERIES
Page 1: ...INSTALLATION INSTRUCTIONS E PLEX 3X00 SERIES NARROW STILE LOCK ...
Page 9: ...9 Notes ...
Page 10: ...10 Notes ...
