© 2006-2007 Kaba Mas Corporation. All rights reserved.
Product warranty information can be found at: www.kaba-mas.com
Kaba Mas Corporation
749 W. Short Street, Lexington, KY 40508 USA
Phone: (859) 253-4744 FAX: (859) 255-2655
Customer Service: (800) 950-4744
Figure 16
Figure 17
Figure 18
13. Insert the bolt into the bolt guide, with the beveled edge facing
away from the mounting surface. (Figure 15)
14. Push the follower back and hold. While using a magnetic
screwdriver, insert the screw through the follower. Screw through the
follower guide and chamber with the remaining 4-40 x 3/8” screw to
secure the follower assembly. (Figure 16)
15. Insert the back mounting plates. (Figure 17)
16. Secure back mounting plates with 4-40 x 1/2” screws. (Figure 18)
******************************************************************************
For a Cross Throw Installation:
(See front of sheet for End Throw.)
8. Place the cam (marked by a C on the back surface) onto the control
shaft, with the post closest to the bolt location. (Figure 19)
10. Place the legs of the follower over the bolt with the tapered side
up and put the spring on the follower. (Figure 20)
11. Place the follower over the chamber and cam with the follower
legs engaging the bolt. (Figures 21 & 22)
Figure 19
Figure 22
Figure 21
11. Insert follower guide into the slot on the chamber and pivot the
follower guide down to position/retain the follower while compressing
the spring to engage the notch on the follower guide. (Figures 23 &
24)
12. Screw through the follower
guide and chamber with the
remaining 4-40 x 3/8” screw to
secure the follower assembly.
(Figure 25)
13. Insert the back mounting
plates. (Figure 26)
14. Secure back mounting plates
with the 4-40 x 1/2” screws. (Figure
27)
Install Bolt Hardware
(If Required)
1. Insert the bolt into the bolt guide with the tapered side up.
2. Mount the bolt guide onto inside surface using 2 Phillips head
wood screws. (Figure 28 - End Throw, Figure 29 - Cross Throw)
Figure 26
Figure 27
Figure 28
Figure 29
Figure 15
Figure 20
Figure 23
Figure 24
Figure 25
Install Strike
(If Required)
1. Install the strike using the two chrome Phillips
head wood screws. (Figure 30)
2. Once adjusted, secure the center of the strike
with the third chrome Phillips head wood screw.
Install Batteries
1. Remove the two screws from
the battery panel and then remove
the panel. (Figure 31)
2. Install two fresh, high quality,
name brand (Energizer
®
or
Duracell
®
) CR-2 lithium batteries.
(Figure 32)
Note:
The negative end of the
battery should be inserted into the
battery cavity first.
3. While the lock is locked, turn the knob forcefully to adjust the KABA
logo to the horizontal position. (Figure 31)
4. Test opening of the lock with the default combination for the model
you are installing: Model CL10 - “5525”, Model CL20 - “111 12345”.
Note:
For the Model CL10, you must test the lock by toggling
between locked and unlocked. To unlock, simply enter the default lock
user combination of “5525”. To lock the lock, enter the default lock user
combination of “5525”. Then press and hold the
key until the yellow
light
Y
displays.
5. Reattach the battery panel (Figure 33) and test the lock once more
with the default combination.
Figure 33
Figure 32
Figure 30
Battery Panel
Figure 31
+
+
-
-
