07
08
DISPLAY & KEY SETTINGS
Driving Mode Selection
Located underneath the main display on the right side of the handle bar you
can find two switches to control driving modes:
The ECO/TURBO switch regulates the power of your scooter. By pressing down the button,
ECO mode is activated which will reduce torque and top speed to maximize range. When the
button is not pressed, TURBO mode is activated and there is no restriction of power.
The SINGLE/DUAL switch toggles single or dual motor drive. By pressing down on the button,
DUAL motor drive is activated. When the button is not pressed, SINGLE (rear) motor drive is
activated.
For maximum range, select ECO mode and SINGLE motor drive. For maximum power and
speed, select TURBO mode and DUAL motor drive.
Display Settings –Wolf Warrior 26Ah
The Wolf warrior 26Ah scooter is equipped with the following display:
Gear change. While the scooter is powered ON, press the POWER button to enter gear setting
mode. Press MODE to switch between gears. Gear 1 is for slow speeds, gear 2 is for medium
speeds, and gear 3 is for fast speeds. To return to operating mode either press POWER or wait
for 2 seconds.
1.Speedometer: Shows the speed at which you are travelling.
2.Battery Indicator: Displays battery levels, do not let it run out
of battery. As a rough guideline, charge at or below 2 bars.
3.
Power Button: To turn the scooter on or o press button for 2 seconds.
4.
Accelerator: Pull to accelerate. The stronger you pull, the faster it accelerates. The scooter is
delivered in “Non-Zero Start” setting (Kick-And-Go is ON). The accelerator only works if the
scooter is already in motion.
5.
Mode Button: Press to select various display options:
MODE
COMMENT
TIME
Time since powering on the scooter.
TRIP
Distance travelled since powering on the scooter.
ODO
Total distance travelled.
VOL
Current battery voltage.
CH2:00
Charging mode. Time (2 hours) scooter stays ON (overrides auto-switch
off) so you can use display’s USB port to charge e.g. your phone.
Detailed P-settings mode.
To access P-settings to make various advanced changes, press
POWER [3] and MODE [5] simultaneously for 2 seconds.
Cycle through the P-settings using the MODE button. To select a P-setting in order to make
changes, press the POWER button. Change the value (up or down) using the MODE (up) and
POWER (down) buttons. To return to the P-settings menu after changing a value, wait 2
seconds. To return to operating mode, wait a further 2 seconds.
05
P-SETTINGS
P0
Tire diameter (11= 11 inch). Do not change.
P1
Controller shut-down voltage. Default set to 52V (minimum is 48V – we recommend 52V to preserve battery life).
P2
Motor magnetic pole setting. Default is 30. Do not change.
P3
Speed signal selection. Default is 0. Do not change.
P4
Distance / speed unit. 0=km, 1=miles
P5
Start setting. 1=non-zero start (Kick-and-Go), accelerator won’t work if scooter is not in motion; 0
=immediate start (CAUTION while using this)
P6
Cruise control. 0=cruise control OFF, 1=cruise control ON.
P7
Initial acceleration. 0=strong, 1=soft.
P8
Electric (regenerative) braking (E-ABS). 0=E-ABS off, 1=E-ABS on
P9
Speed limit as % of top speed, i.e. 100=no speed limit.
PA
Clear total distance travelled (ODO).
PB
Scooter auto-turn off time in minutes.
PC
Display brightness (1=low, 2=medium, 3=high)
