MOCCA compact 2.3
Pin out of the Connectors 10
3
Pin out of the Connectors
In the following sections the pinning of the different input output connecters are described. Please
note that some signals may not be available on a specific hardware or software configuration.
3.1
Connectors on the Back
In the illustration below you can find annotations which indicate the table index which describes the
respective connectors pinning.
Illustration 3-1: Connectors seen from the supply side
3.1.1
High Speed CAN
The provided GND pins must not be used unless there is no other GND connection. These pins must
not be used for supply purpose.
Pin No.
Signal
Description
1
CAN5-Low
LOW-level CAN bus line
2
CAN1-Low
LOW-level CAN bus line
3
GND
Signal ground
4
CAN3-Low
LOW-level CAN bus line
5
-
Not connected
6
-
Not connected
7
CAN1-High
HIGH-level CAN bus line
8
CAN5-High
HIGH-level CAN bus line
9
CAN3-High
HIGH-level CAN bus line
Table 3-1: Pinning of Connector High Speed CAN 1/3/5