KTI63502A 11/10/2019
INSPECTION AND SETUP INSTRUCTIONS
Visual inspection should be made before each use of the transmission jack, checking for leaking hydraulic fluid and damaged, loose or
missing parts. Each jack must be inspected by a manufacturer’s repair facility immediately if accidentally subjected to an abnormal
load or shock. Any jack which appears to be damaged in any way, found to be badly worn, or operates abnormally MUST BE
REMOVED FROM SERVICE until necessary repairs are made by a manufacturer’s authorized repair facility. It is recommended that
an annual inspec-tion- of the jac
k be made by a manufacturer’s authorized repair facility and that any defective parts, decals or
warning labels be replaced with manufacturer’s specified parts. A list of authorized repair facilities is available from the manufacturer.
Refer to parts breakdown on page 5 and 6 :
Attach two legs (67) to the base (47) using bolts (39) and lock washers (69) washers (66).
Fit four casters (68) to the legs (67) using nuts (65), washers (66) and lock washers (69).
Put the saddle (21) onto the top of the ram (22) and slide it onto the shaft.
1.
NOTE:
All four caster wheels may not simultaneously come in contact with the floor due to uneven floors or tolerances in mating
jack parts. This will be corrected when jack is in place and load has been applied.
2. Sometimes air can get trapped in the hydraulic system due to shipping and/or handling. An air-trapped system is identified by a
limited effective pump stroke during operation, a spongy feel to the pump or failure to extend the ram to maximum height.
FOLLOW THESE INSTRUCTIONS TO PURGE AIR FROM THE HYDRAULIC SYSTEM
Turning the release handle (02) to the right and turning the air vent screw (19) counterclockwise by one turn then pumping the foot
pedal (60) 15 to 20 times. Please tightening the air vent screw (19) clockwise after the exhausting.
Test the jack without load, by raising it to full height and then lowering it. Open the release handle to lower the load.
Note: This jack is equipped with a speed limiting valve so that the descent speed is controlled automatically instead of
controlled by the release handle.
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to
potential personal injury hazards. Obey all instructions to avoid possible injury or death.
Roll the transmission jack into position and pump the foot pedal (60) until saddle (21) reaches desired height.
NOTE: Follow vehicle manufacturer
’s recommended procedures for removing the load as outlined in vehicle service
manual or repair guide.
Carefully center load on the saddle. Ensure the load's center of gravity is centered on the saddle and the setup is stable and secure.
Use the chain to hold the load if necessary.
NOTE: Before lowering load check to ensure all tools and personnel are clear and it is safe to lower the load.
Turn the release handle (02) to the right to lower the load to its lowest possible position.
NOTE: This jack is equipped with a speed limiting valve so that the descent speed is controlled automatically instead of
controlled by the release handle.
WARNING! Dangerous dynamic shock loads are created by quick opening and closing the release handle when the load is being
lowered. The resulting overload may cause hydraulic system failure which could cause property damage and/or severe personal
injury.
If necessary, CAREFULLY and SLOWLY move the jack.
Transfer load immediately to appropriate support device for service or repair.
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you
to potential personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the transmission jack in a well protected area where it will not be exposed to inclement weather, corrosive vapors,
abrasive dust, or any other harmful elements. The jack must be cleaned of water, snow, sand, grit, oil, grease or other foreign
matter before using.
