Ver.00
07 Febbraio 2019
13
LED Description
The Charging LED GREEN indicates that the battery charger in the External Battery Pack is charging
normally with the AC power cord attached to the Battery pack.
The Battery Test LED GREEN indicates that the DC output of the External Battery Pack is normal.
To perform the Battery Test.
•
switch on the breaker on the rear of the Battery Pack
•
press the Battery Test Button on the front panel of the Battery Pack
•
the DC output from the Battery Pack is normal when the Battery Test LED is on
Before connecting Battery Pack, test each Battery Pack to assure proper operation.
9
4.Rear Panel Description
1KVA /2KVA/3KVA Battery pack rear panel
Figure 3 1KVA/2KVA/3KVA Battery pack rear panel
1. The DC Circuit Breaker connects and disconnects the DC bus voltage from the Battery pack to the
UPS. The DC Circuit Breaker will disconnect in the event of an over-current condition.
2.
The External Battery connector is for Daisy Chaining additional Battery Packs and/or connecting
to the UPS.
3.
The AC Inlet is for connecting the input power cord to operate the Charger.
4.
The Input AC Breaker will disconnect in the event that the Internal Charger draws excessive
current.
5.
The External Battery cable is for connecting the Battery Pack to the UPS or Daisy Chaining
additional Battery Packs.
CONNECTING THE BATTERY PACK TO AN AC POWER SOURCE
Battery Packs require 220V input voltage, each socket permits only three battery packs’ input power
cord to be plugged in.
1. Connect the Battery Pack input power cord into the AC inlet on the Battery Pack.
2. Insert the “plug” end of the input power cord for the Battery Pack into the AC wall outlet. Only
utilize a two-pole, three-wire grounded receptacle. Do not use additional cords, outlet strips or surge
strips.
