KNX/EIB
Switch Actuator with Secure
50
5.2. Communication object “Switch actuator”
5.2.1. General communication object “Switch actuator”
Fig. 5.2.1 General communication object per output
No.
Function
Object name
Data byte
Flags
DPT
4
Switch status
Output A-{{...}}
1bit
C,R,T
1.001 switch
This object will be enabled when selecting “Transmit after change/Respond after read only” in the
parameter “Set the reply mode of switch status”, which will indicate the contact status (details will be
defined by parameter “Object value of switch status” in “Channel X”).
The name in parentheses changes with the parameter “Description (max.30 char.)”. If description
is empty, display “Output A-...” by default. The same below.
5
Switch
Output A-{{...}}
1bit
C,W
1.001 switch
This object is used to trigger the switch operation. It will start the switch operation with ”1”, and
end with “0”.
When enabling “input 0” in the logic function, the object “Switch, X” is used to modify the logic
value of “input 0”, rather than trigger the switch operation.
Table 5.2.1 General communication table per output
