KNX/EIB
Switch Actuator with Secure
18
4.4. Parameter window “Channel X”-Switch actuator
Fig. 4.4(1) Parameter window “Channel X”
–
Switch actuator
Parameter “If bus recovery,output status is”
The output can adopt a defined status on bus voltage recovery via this parameter. Options:
Unchange
Contact open
Contact close
As before bus failure
When selecting “Unchange”, the contact of the relay will remain the same as the last status before
power off;
When selecting “
Contact open
”, contact of the channel will be opened when the bus power on;
When selecting “
Contact close
”, contact of the channel will be closed when the bus power on;
When selecting “
As before bus failure
”, contact position after voltage recovery is the same as that
before power on.
NOTE: After finished application programming, all output channels will remain the same status.
