8
Vyper-KV
USER GUIDE
Wiring
For easy connectivity and link, the Vyper-KV line array
loudspeakers feature Euroblock 2 pin inlets, namely for Phoenix
2,5/ 2-ST-5,0 flying plug.
Caution must be taken when connecting the loudspeaker cable
to the flying connector in order to match the signal polarity:
please refer to the label on the rear panel of the loudspeaker for
the correct matching.
For a cable run of up to 5 m (16.4 ft) use wire gauge of 0,75 mm
2
(18 AWG) minimum. For longer cable runs a wider gauge is
recommended.
1.
Set the proper speaker cable length for connecting the
loudspeaker to the amplifier;
2.
Connect the speaker cable to the two terminals connector,
taking care to respect the signal polarity;
3.
Set the proper impedance value according to the
loudspeaker configuration and amplifier model.
4. Plug the speaker cable to the signal connector on one
loudspeaker end;
In application demanding IP65 devices:
A.
Cut a small aperture on the IP65 connector sealing plate’s
rubber;
B.
Let the speaker cable passing through the IP65 connector
sealing plate’s rubber;
C.
Connect the speaker cable to the two terminals connector,
taking care to respect the signal polarity;
D.
Set the proper impedance value according to the
loudspeaker configuration and amplifier model.
E.
Remove the connector plates from the loudspeaker back
panel;
F.
Screw both IP65 connector sealing plates on the
loudspeaker back panel.
A
B
C
D
E
2
3
4
F
Torx T10
6 mm
[0.25 in]
12 mm
[0.5 in]
