PCIe/PXIe-6301 Series |
| 20
4.
Operating PCIe/PXIe-6301 Modules
This chapter provides the operation guides for PCIe/PXIe-6301, including RTD
measurement and programmable I/O interface, etc.
JYTEK provides extensive examples, on-line help and documentation to assist you to
operate the PCIe/PXIe-6301 board. JYTEK strongly recommends you go through these
examples before writing your application. In many cases, an example can also be a
good starting point for a user application.
Quick Start
After you have installed the driver software and the SeeSharpoTols, you are ready to
use Microsoft Visual Stuidio and our C# measurement and control platform tools
(SeeSharp Platform) to operate the PCIe/PXIe-6301 products.
If you are already familiar with Microsoft Visual Studio C#, the quickest way to use
PCIe/PXIe-6301 is to go through our extensive examples. We provide source code of
our examples. In many cases, you can modify the source code and start to write your
applications.
AI Operations
When performing AI operations, it will be helpful if you understand the characteristics
of the signal to be acquired, then configure PCIe/PXIe-6301 accordingly. Once
configured, you can use our tools to read data and save it in the memory or on a disk
for your future analysis. Please see the provided software examples for more
information.
Learn by Example 4.2
◼
Connect the PT100’s positive pole to AI+ (Pin#35), the negative poles to AI
- (Pin#1)
and Ex- (Pin#36);
◼
Open
Winform AI Continuous,
set the following numbers as shown. Choose
ThreeWire
in
RTD Terminal;
