TURNTABLE OPERATION
POWER SUPPLY
Insert the adaptor plug into the DC IN jack on the rear of the unit, then connect the
AC/DC adaptor (5V, 1A / AC100-240V, 50-60Hz) to a AC/DC wall outlet.
BASIC OPERATION
1. Lift the BUCKLE on the front of the turntable and open the lid.
2. Power on the unit by turning the VOLUME CONTROL KNOB clockwise. The red
LED will light to show that the turntable is turned on. Turn the FUNCTION KNOB
to the PHONO position. NOTE: LED will be blue if switched on in Bluetooth mode.
3. Place a record on the TURNTABLE PLATTER and select the desired speed (33 1/3 /
45 / 78) by sliding the SPEED SELECTION SWITCH according to the record.
NOTE: When playing a 45 rpm record, use the included 45 RPM ADAPTOR
located in the holder near the tone arm.
4. Open the TONE ARM CLIP to release the TONE ARM. Push the LIFT LEVER
backwards to raise the arm. Gently move the tone arm to the desired position
over the record. The turntable will begin to spin when the arm is moved toward
the record. Push the lift lever forward and lower the arm slowly onto the desired
position on the record to begin playing.
Please Note: The record will begin to spin only when the tone arm is moved over
the record if the Auto Stop is turned ON.
5. If the AUTO AND MANUAL STOP SELECTION SWITCH is turned ON, the record
will stop automatically when finished. If this switch is OFF the record will NOT
stop automatically when finished.
NOTE: Some Records DO NOT allow AUTO STOP. In some circumstances,
even though you have AUTO STOP selected the record will continue to spin.
6. To select the volume level, turn the VOLUME CONTROL KNOB to adjust the volume.
HOW TO REPLACE THE TURNTABLE NEEDLE
Removing the Stylus from the Cartridge
1. Place a screwdriver at the tip of the stylus and push downward as shown in
direction "A
"
WARNING: when applying force to stylus, too much may damage
or break the stylus.
2. Remove the stylus by pulling the stylus forward and pushing downward.
Installing the Stylus
1. Hold the tip of the stylus and insert the stylus by pressing as shown in direction 揃?
2. Push the stylus upward as in direction "C" until the stylus locks into the tip position.
5
Guide Pins (Inside)