POWER SOURCE
BATTERY POWER OPERATION
1.
Open the BATTERY DOOR by rotating the BATTERY DOOR OPEN KNOB in the direction of the
arrow shown on the unit.
2.
Install 4 x "C" size (UM2) batteries carefully as indicated in battery compartment.
3.
Close the BATTERY DOOR and rotate the BATTERY DOOR OPEN KNOB in the reverse direction
to make sure the BATTERY DOOR is fully locked.
Note :
* For battery operation the AC power adaptor must be disconnected from the DC jack.
* When the batteries are low, erratic information may appear on the DISPLAY. In order to reset the
display, remove the old batteries and install new batteries after waiting 5 minutes.
* Use batteries of correct size and type only.
* Maintain correct polarity when installing batteries.
* Do not mix different types of batteries, or old and new batteries.
* Old batteries can leak and cause corrosion so never leave run down batteries in your unit.
* Remove batteries when the unit will not be used for a long period of time.
* Follow the battery manufacturer's instructions.
AC POWER ADAPTOR OPERATION (NOT INCLUDED)
1.
Pull out the DC Jack Cover.
2.
Use only a suitable AC power adaptor. - DC6V 600mA, center positive.
3.
Note the polarity (center "+") and input voltage indicated on unit.
4.
Make sure to use a correct adaptor that matches the size of the DC jack.
5.
Connect the AC adaptor plug to the DC jack of the unit and plug the adaptor into an AC outlet.
Note:
*
Always disconnect the AC adaptor plug from the DC jack when using batteries to power the unit.
*
Remove the AC adaptor from the outlet when the unit will not be used for a long period of time.
LISTENING WITH THE HEADPHONES
Pull out the Headphones Jack Cover. Connect stereo headphones (not included) into the PHONES JACK.
It will automatically cut off the sound output from the built-in speakers.
CAUTION : Avoid excessive volume levels and listening to sound for a long period of time when using
headphones, as this may damage your hearing.
LISTENING WITH THE BUILT IN SPEAKERS
If you do not plug headphones into the unit, then the unit will use the built-in speakers for sound output.
VOLUME CONTROL
Rotate the VOLUME KNOB to change the volume output level.
PLAYING COMPACT DISC
Slide the CD DOOR LOCK KNOB to the open position and open the CD DOOR. Place a CD into the
compact disc compartment and close the CD DOOR. Remember always slide the CD DOOR LOCK
KNOB to the lock position before using the unit.
Set the FUNCTION SWITCH to CD position.
JWIN JXM85 (English)-1.p65
2003/12/20, ¤U¤È 12:54
4
