PAGE
4
2.2.6. 3
Repeat message
- Press “ MEMO/REPEAT” key to replay the repeat current message or press twice to
replay previous message.
- When last is completed it announces “End of message”.
2.2. 6.4
Erase single message
- Press “ ERASE ” key to erase the message currently being played back.
2.2. 6. 5
Stop message play
- Press “ PLAY/STOP ” key to abort the message play.
2.2. 7
Playing new ICM Messages
Procedure of playing new messages is as follows:
- If new message(s) has/have been recorded, the ANSWER ON/ OFF LED will keep
flashing.
- Press the “ PLAY/STOP ” key, the new messages will be sequentially played
- If DTS has been set, the total number of messages DTS is first played. Then each
message is played with message number. DTS played first and clock DTS played last.
- The ANSWER ON/ OFF LED will stop flashing but will be turned on after all new
messages have been played to indicate the absence of new messages.
2.2.8
Recording a Memo
Memo is a message left for others who directly access to the answering machine.
- Press and hold the “ MEMO/repeat ” key for about 2 seconds. Release the key after a
short beep, LED displays “oo”. Memo recording will then start after a long beep. The
display will count up from “0” to show the duration of the recording.
- Stop recording by pressing “ PLAY/STOP ” key once. Recording will stop
automatically after 1 minute.
- AMSWER ON/OFF
LED
will flash to indicate the presence of new memo.
2.2.9 Two-way Conversation Recording
- Press and hold the “MEMO/REPEAT” key for about 2 second. The LED display shows
“oo” and a short beep is generated. Keep pressing the key until the display shows “2A”.
Release the key and two-way recording starts.
- Recording will stop if “STOP” key is pressed, or if silence, busy tone or continuous
tone is detected.
- The display will blink “ oo ” and the ANSWER ON/OFF LED will flash to indicate the
presence of newly recorded conversation.
2.2. 10
Play Memos
- If new memos and /or conversation are recorded, the display will blink “oo”
- Press the “ MEMO/REPEAT2WAY ” key once, only the MEMOS and/ or two-way
conversation will be sequentially played. The display will stop blinking “oo” after all
memos or conversations have been played.
- The ICM message will not be played. However, the user may press “PLAY/STOP” key
to play all kinds of messages.
- The other procedure is similar to “Play all message” step.
- If new message(s) is/are record, the ANSWER ON/OFF LED will flash. However, if the
user just presses “MEMO/REPEAT” key to play back messages, that LED will keep
flashing after the end of playback