1-7
Fig. 1-2-2f STROBE BOARD ASS’Y
852
857
856
855
858
854
859
854
853
875
861
860
870
868
869
862
864
863
866
865
867
871
871
876
874
872
PART.NO
0.09
±
0.009 N•m
A
B
B
A
<M2> VF ASS'Y(G)
VF ASS'Y(G) LYH20621
FRAME(VF)2
EARTH SHEET
SPACER(A)
GUIDE(OUTER)
GUIDE(OUTER) ASS'Y
CASE(VF) ASS'Y
STP RING
COMPRES.SPRING
GUIDE SCREW
GUIDE SCREW
LENS HOLDER ASS'Y
S.GUIDE ASS'Y
SHEET(LENS)
EYE CUP
V.ADJ.PLATE
S.PLATE
V.ADJ.KNOB
VFBW BOARD ASS'Y
VFCL BOARD ASS'Y
B.LIGHT CASE
B.LIGHT CASE
SHEET(DIFF)
SHEET(POLA)
SHEET(POLA)
CUSHION(LCD)
CUSHION(LCD)3
LCD MODULE
LCD HOLDER
LCD HOLDER2
FRAME(VF)
FRAME(VF)2
SHEET HOLD
E-CARD WIRE
(L852a)
(WR851a)
CONCLUSION SCREW TORQUE TABLE
TORQUE
ALL SCREW
BLOW OUT AIR.
BLOW OUT AIR.
BLOW OUT AIR.
BLOW OUT AIR.
BLOW OUT AIR.
BLOW OUT AIR.
PASTE TAPE TO LCD RESPECT,
AND PEEL OFF TAPE.
BLOW OUT AIR.
PASTE INSIDE THAT EXFOLIATION
PAPER'S COLOR IS TRANSPARENT.
DRAWING FOR EARTH SHEET STICKING.
TURN
TURN
PASTE
SHUOLD BE MATCHED KNOB
TO FULL LEFT SIDE.
(REFER TO THE CHART)
DIOPTER ADJUSTMENT CONTROL
PROCESSING SPACER(A)
DON'T RUN A GROUND ON
THIS CONNECTOR.
LESS THAN 1mm.
B/W VF
COLOR VF
REEL DISK
ASSY (SUP)
PVC TAPE
(DC3V)
1.3 Manually removing the cassette tape
The following procedure describes a simplified method of eject-
ing the cassette tape in case it is not possible to eject it, due
to an electrical failure.
Be careful not to damage any of the parts or the tape when
performing repairs or maintenance work.
(1) Remove the Power Unit (battery, DC code, etc.) from the
main unit.
(2) Open the Cassette cover.
(3) Attach a piece of PVC tape at the front of the Cassette hous-
ing.
This helps prevent the tape from being damaged when the
Cassette housing assembly is moved upward at the unload-
ing end.
(4) Apply DC3V to the electrode on the top surface of the Load-
ing motor assembly to set the Mechanism assembly to the
eject mode.
Unloading end is eject mode.
(5) If there is any slack tape in the tape transport system, wind
it inside the cassette tape by turning the Reel disk (SUP)
from the backside of the Slide deck assembly.
(6) Peel off the PVC tape and take out the cassette tape from
the Cassette housing.
Make sure that grease or a similar substance is not attached
to the surface of the tape.
Similarly, also make sure that grease or a similar substance
is not attached on the Mechanism assembly.
Fig. 1-3a
