Unscrew the cover
Disconnect the grounded wire to the cover
Disconnect the sensor lead out wire
Drill in the wall 4 holes
– diameter 8mm
Insert the power wire in the hole and fix the appliance on the wall.
Connect the power supply to the connecting block.
The power wire must be at the back of the appliance and must be out of reach when the hair dryer
is screwed on the wall. The section of the wires has to be 2,5mm².
If not, you must use the drilling clamp supplied with the appliance.
Connect the grounded wire to the cover and the sensor wire. Then screw the cover.
USE
Automatic version : The appliance automatically starts when you put your hands under the unit.
Manual version : Push the big squared button on the cover. The appliance runs for 30 seconds.
ADJUSTMENT OF THE SENSITIVITY (automatic version only)
Remove the cover.
The sensitivity of the appliance can be adjust with the potentiometer (figure 2
– n°8) thanks to a
screwdriver.
When you turn clockwise the hair dryer will be more sensitive.
If you turn anticlockwise the hair dryer will be less sensitive.
GUARANTEE
Faulty connection or any damage resulting from wrongly usage or which is in contradiction to the
instructions in this leaflet will render the guarantee void.
The installation is made in the buyer's responsibility
This equipment complies with the regulations in European directives 2014/35/CE, 2014/30/CE and
2011/65/EC
