1-20 (No.XA014)
4.7.1
Tool for adjustment
*Stud: One set (four studs), Part number: JIGXVS40 (Note: One of the four studs is not used here.)
* Relay board and extension cord (One set) --- Parts number : EXTXVN30CB
*The phillips screwdriver for adjustment --- goods on the market
*Test disc ---- Parts number : VT-501
4.7.2
Preparation for adjustment
(1) A mechanism assembly is removed with reference to the disassembly method of a service manual.
(2) When the card wire which has connected the power supply board and the output terminal board is extracted at this time, please
connect again.
(3) Three stud is attached in a mechanism assembly, respectively.
(4) Remove the servo control board attached the mechanism assembly.
(If you disconnect the wires connected to the servo control board, connect them again.)
(5) The relay board 2 is connected to the connectors
CN601
and
CN701
on the output terminal board.
(6) The relay board 4 is connected to the connectors
CN902
on the power supply board.
(7) The relay board 1 is connected to the connectors
CN502
and
CN503
on the servo control board.
(8) The relay board 3 is connected to the connectors
CN501
on the servo control board.
(9) Between relay boards, an extension code is inserted, respectively and it connects.
(Be careful of direction of a card wire at this time.)
-- Items --
Relay board 1 : EXTXVN30CB-1
Relay board 2 : EXTXVN30CB-2
Relay board 3 : EXTXVN30CB-3
Relay board 4 : EXTXVN30CB-4
Card wire : 15 pins 15 cm 2 pcs
Card wire : 9 pins 15 cm 1 pcs
1
2
3
4
5
6
1
2
3
4
5
5
6
Relay board 2
Relay board 4
Relay board 3
Relay board 1
Stud
Stud
Output terminal
board
Power supply board
Servo control board
1
2
3
5
5
5
5
6
6
4
Summary of Contents for XV-N30BK(MK3)
Page 33: ... No XA014SCH 2 7 MEMO ...