XL-R5020BK
16
3.1.7 Removing the pickup
(See Fig.21 to 25)
(1) From the top of the body, remove the three screws
H
attaching the clamper base unit.
(2) Remove the clamper base unit with the two rods attached
to the clamper base unit and the top cover.
(3) Turn the screw shaft gear marked
k
in the direction of the
arrow to move the pickup unit.
(4) Remove the screw
I
attaching the shaft holder.
(5) Move the screw shaft in the direction of the arrow and
release it from the joint
l
. Then release it from the joint
m
with the pickup holder. Detach the pickup with the screw
shaft.
(6) Solder the part
n
of the flexible board on the underside of
the pickup. After soldering, disconnect the flexible wire
connected to the pickup (In case of disconnecting the
flexible wire without soldering, it may cause damage to the
CD pickup).
(7) Remove the two screws
J
attaching the rack arm to the
pickup unit.
(8) Pull out the screw shaft from the pickup.
Fig.21
Fig.22
Fig.23
Fig.24
Fig.25
