SNTP Server
Sets an IP address of NTP server.
[Factory default: 0.0.0.0]
Interval
Sets a unit and values of measurement for the time
interval at which to access the NTP server.
[Set values: Min(1-60),
R
Hour(1-24), Day(1-31)]
Time
Displays the clock time of camera.
You can correct the time by entering a value
(without seconds).
Memo :
0
The time is recorded in the JPEG header and
H.264 header distributed by the camera.
Discontinuity may occur in the time of the JPEG
header and H.264 header immediately before
and after changing the time.
0
Change the [Time] if it does not coincide with the
[Time Zone] of the region you are residing.
Time Zone
Sets a time zone.
[Set values: (GMT-12:00) to
R
(GMT)UTC to (GMT
+12:45)]
Memo :
0
After changing the [Time Zone], check to ensure
that the [Time] is correct. If it is incorrect, readjust
the [Time] accordingly.
Note :
0
When the [Time Zone] settings are changed to
a value different from the factory default, they
cannot be restored to the factory settings even
by initializing using [All Settings] on the
[Maintenance] page.
PC Time to Camera
Click [Set] to set the computer’s time on the
camera.
[Password] Page
This page sets a password.
This page can be used during access using
“admin”.
Note :
0
Be sure to handle the password carefully in case
you forget it.
0
If you have forgotten the password, please
consult our service center.
Settings
.
80
[Advanced Settings] Page - [Time] Page
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er
