IP Address
Sets the IP address of camera.
[Factory default: 192.168.0.2]
Subnet Mask
Sets the subnet mask of camera.
[Factory default: 255.255.255.0]
Default Gateway
Sets the default gateway of camera.
Enter 0.0.0.0 if you do not want to set a default
gateway.
[Factory default: 0.0.0.0]
Host Name
Sets a host name of camera.
It can consist of alphanumeric characters, hyphen
(-), and period (.). Underscore (_) character is not
allowed to use.
DNS Server
Sets an address of DNS server.
[Factory default: 0.0.0.0]
MAC Address
The MAC address of camera is shown as a
hexadecimal number.
Other
Negotiation
Sets the network negotiation.
If you have selected a value other than “Auto”, do
not set the connected network device to “Auto”. Be
sure to set it to the same value as the camera.
[Set values:
R
Auto, 100M Full, 100M Half, 10M
Full, 10M Half]
Note :
0
The camera and another connecting device on
the network may connect automatically when
other than “Auto” is selected for the camera and
“Auto” is set for the other connecting device.
0
When connection is established with “100M
Half” or “10M Half”, restriction on the
communication line applies, and sending and
receiving cannot be executed simultaneously. If
video streams are distributed from the camera
in this state, sending of instructions such as pan/
tilt/zoom (PTZ) operation to the camera may fail.
MTU
Sets the maximum size of packets which contain
visual data.
[Set values: 1280 to
R
1500]
[Protocol] Page
This page sets the protocol.
This page can be used during access using
“admin”.
Memo :
0
Press the [OK] button to enable the new
settings.
0
If the [OK] button is pressed upon entering an
invalid value, a warning message will appear
and the entry will be denied. Press the [Cancel]
button to restore the invalid entry to the value
before the change was made. If you press the
[Cancel] button, other changed items will also be
restored to the values before the change was
made.
0
When you connect via Internet Explorer after
changing protocol settings, enter the address
using the new server port and port number in the
address bar.
Settings
.
* Setting values with
R
are default values.
[Advanced Settings] Page -[Network] Page
75
Se
tti
ng
Us
in
g In
ter
net
E
xplor
er
