JVC VN-H237VPU, Instructions Manual, Page: 44 / 114

44
Internet Explorer Setting
PTZ Page
This page sets the movement speed for Auto Return and Preset Position.
This page can be used during access using
A
admin
B
or
A
operator
B
.
●
First, set the frame size to 640 x 360 or 640 x 480 in the [Encode] page. (
A
Page 24)
Memo:
●
Press the [OK] button to enable the new settings.
●
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the
change was made. If you press the [Cancel] button, other changed items will also be restored to the
values before the change was made.
Note:
●
You can use the Digital PTZ for frame sizes 640 x 360 and 640 x 480 only. (
A
Page 16)
* The [Set values] in bold letters are factory defaults.
Settings (continued)
B
A
Click [Advanced Settings] and [PTZ].
A
Auto Return Restores automatically to the state being specified under [Mode] if the
manually operated camera is not operated for the time period specified by
[Return Time].
Mode Sets an action taken after Auto Return.
Disable : Disables the auto return.
HOME : Returns to the home position.
Auto Patrol : Restores the auto patrol action.
[Set values: Disable , HOME, Auto Patrol ]
Return Time Sets a time before restoring the action by Auto Return.
[Set values: 1 min , 2 min, 3 min, 5 min, 10 min, 20 min, 30 min, 60 min ]
Test Click [Execute] to test the Auto Return action.
B
Preset Position
Speed Specifies the speed to move to the preset position.
Memo:
●
The speed to move the preset position of Auto Patrol is not specified in this
setting as the setting of the speed to move the Auto Patrol page is applied.
Speed [Set values: Moment , Low, Mid, High ]