JVC VN-H237VPU, Instructions Manual

Page: 24 / 114

24
Internet Explorer Setting
Encoding Page
This page sets JPEG/H.264/MPEG-4 encoding parameters.
This entry links to the [Encode] item of "Basic Setting2" page. (
A
Page 16)
This page can be used during access using
A
admin
B
or
A
operator
B
.
Memo:
●
Press the [OK] button to enable the new settings.
●
If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the
change was made. If you press the [Cancel] button, other changed items will also be restored to the
values before the change was made.
●
Encoding settings cannot be changed during multicast distribution. (
A
Page 59)
●
If settings on this page are altered during playback using the Built-in Viewer, reboot the viewer.
●
There is upper limit to transmission bit rate from the camera. If a bit rate that exceeds upper limit is
specified, this new setting will not be applied. For details on the maximum transmission limit, refer to
the section on "Network". (
A
Page 4)
●
H.264 High indicates High Profile, and H.264 Baseline indicates Baseline Profile.
●
The contents displayed in
C
changes depending on the type of encoding and the item selected.
●
If the distribution bit rate exceeds 24 Mbps, the specified frame rate distribution fails.
●
Only encoding channels of either H.264 High or H.264 Baseline with a bit rate of 1024 kbps or lower
can be recorded to the SD card.
●
Do not change any settings on the encoding settings page while recording to an SD card.
Settings (continued)
C
B
D
A
Click [Advanced Settings] and [Encoding].