JVC UX-V30, Service Manual

Page: 9 / 68

1-9
UX-V30
Disconnect the harness from connector CN721 and
CN722, and the card wire from CN766 on the LCD
board on the back of the front panel assembly.
Remove the five screws M attaching the CD
mechanism cover to the front panel. Remove the CD
mechanism cover together with the CD mechanism
assembly.
Release the harness from each hook on the CD
mechanism cover.
Remove the five screws N attaching the CD
mechanism cover and the CD mechanism case.
Release the three joints g of the CD mechanism
cover and the CD mechanism case by pushing the
joint hooks inward.
Disconnect the card wire from connector CN603 and
the harness from CN605 on the CD servo control
board.
Remove the CD mechanism assembly from the CD
mechanism cover by pulling out it from the three
bosses h.
1.
2.
3.
4.
5.
6.
<Front panel assembly>
Removing the CD mechanism assembly
(See Fig.18 to 21)
Remove the screw O attaching the LED board (A). 1.
Removing the LED board (A)
(See Fig.21)
Prior to performing the following procedure, remove
the rear cover, the side panels, the cassette
mechanism assembly, the main board and the front
panel assembly.
Fig.18
Fig.19
Fig.20 Fig.21
M
M
M
R
CD mechanism cover
(CD mechanism assembly)
LCD board
CN766
CN721
CN722
Loading motor
Belt
Joint g
CD mechanism
case
Loading motor
CD mechanism cover
N
Joint g
Joint g
N
N N
CD mechanism cover
CD mechanism case
Joint g
CD mechanism cover
LCD board (A)
CD servo control board
CN603
CN605