– 8 –
English
Continued
Connecting Speakers
R
L
–
–
+
+
R
L
SPEAKER IMPEDANCE
MIN 4
Ω
To connect speakers
You can connect the speakers by following the procedure
below:
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Open the speaker terminal.
3
Insert the end of the speaker cord to the terminal.
Match the polarity: White cord to red (+) terminal and
black cord to black (–) terminal.
4
Close the speaker terminal on the rear of the unit.
Use only speakers with the speaker impedance—4
Ω
to16
Ω
.
Speaker cord
Speaker cord
Black
Rear of the right
speaker
Rear of the left
speaker
Red
1
Speaker terminals
3,4
2
To remove the speaker grilles
The speaker grilles are removable.
To remove the speaker grille,
insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille,
put the projections of the
speaker grille into the holes of the speaker.
Connecting Other Equipment
You can connect both of the analog and digital equipment.
When you connect and use the equipment, refer also to its
manual supplied.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
OPTICAL DIGITAL OUT
terminal
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and
the OPTICAL DIGITAL OUT terminal.
Before connecting the other equipment,
remove the protective cap from the
terminal.
Protective cap
Audio equipment with
an optical digital input
Projections
Holes
Speaker grille
EN01-09UX-A52[UW]_f
01.12.18, 2:34 PM
8
