1-28 (No.MB260)
3.5.2 Removing the front board
(See Figs.2 and 3)
• Prior to performing the following procedures, remove he side
panel (L) and side panel (R).
(1) From the right side of the receiver assembly, remove the
four screws
B
attaching the front board. (See Fig.2)
(2) From the back side of the receiver assembly, remove two
screws
C
attaching the front board. (See Fig.3)
(3) From the right side of the receiver assembly, take out the
front board, and disconnect the wires from the connectors
CN151
,
CN152
,
CN171
and
CN172
on the front board.
(See Fig.2)
Caution:
When attaching the front board, exchange the spacer for the
new part. If the front board is attached without exchanging the
spacer, the chip parts may be damaged. (See Fig.2)
3.5.3 Removing the rear panel
(See Figs.3 and 4)
• Prior to performing the following procedures, remove he side
panel (L), side panel (R) and front board.
(1) From the back side of the receiver assembly, remove the
two screws
D
attaching the rear panel. (See Fig.3)
(2) From the right side of the receiver assembly, cut off the tie
bands. (See Fig.4)
(3) Take out the rear panel with RF module. (See Fig.4)
Fig.2
Fig.3
Fig.4
Front board
CN172
CN152
CN151
CN171
B
Spacer
Rear panel
D
C
Rear panel
RF module
Tie bands
