JVC sp-pwm45, Service Manual

Page: 22 / 105

1-22 (No.MB067)
3.2.12 Removing the side (R) assembly
(See Fig.22 to 26)
• Prior to performing the following procedures, remove the tray
assemblies and DVD servo board.
• When removing the DVD servo board, it is not necessary to re-
move the DVD servo board from the bracket.
(1) From the inside of the side (R) assembly, release the two
tabs t of the gear cover and remove the gear cover out-
ward. (See Figs.22 and 23.)
(2) From the right side of the DVD changer mechanism as-
sembly, remove the elevator spring attached to the hook u
of the chassis assembly. (See Figs.23 and 24.)
(3) From the topside of the DVD changer mechanism assem-
bly, turn the gear 1 clockwise to move the elevator cam
rearward. (See Fig.24.)
(4) Move the two slots v and joint w of the elevator cam and
remove the elevator cam outward. (See Fig.24.)
(5) Remove the three screws U and detach the side (R) as-
sembly upward. (See Figs.25 and 26.)
Caution:
When reattaching the side (R) assembly, make sure to fit the
shaft (part x) into the slot of the select lever. (See Fig.25.)
Fig.22
Fig.23
Fig.24
Fig.25
Fig.26
t
Side (R) assembly
Side (R) assembly
Elevator spring
Gear cover
Elevator cam
u
Gear 1
Chassis assembly
Elevator cam
Elevator spring
u
v v w
U
Side (R) assembly
U
U
x
Select lever
Side (R) assembly
U
U