RIGHT
LEFT
7
Connecting the speaker cord
Connect the speaker cord to the speaker as illustrated.
• Make sure to match the polarity (
ª
and
·
); otherwise, the
surround effect will become less effective.
Connection
7
Connecting the speaker system to the amplifier
Before connection—
• Turn off the power to the amplifier before connecting the
speaker system; otherwise, the speakers may be damaged.
• The impedance of the speaker is 6
Ω
. Before connecting it to
your amplifier, check the speaker impedance range of your
amplifier. If the impedance of this speaker is out of the speaker
impedance range indicated on the amplifier, you cannot
connect this system to the amplifier.
• The maximum power handling capacity of the SP-F508 is
100 W. Excessive input will result in abnormal noise and
possible damage.
• Be sure to turn down the volume level to prevent unwanted
noise before performing following operations:
– Turning on or off other components,
– Operating the amplifier,
– Tuning FM stations,
– Fast-forwarding a tape,
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds.
• When using a microphone, do not aim it at the speakers or
use it near the speakers; otherwise, the howling which occurs
may damage the speakers.
• Before replacing the cartridge, always turn off the power to the
turntable; otherwise, the clicking noise may damage the
speakers.
• Speaker cords are supplied to the speakers. When using other
speaker cords, observe the following;
– Buy thick speaker cords rather than thin cords, and make
them as short as possible for connection.
– Use speaker cords of the same length for both left and right
speakers.
– Do not use long speaker cords; otherwise, the sound quality
may deteriorate.
– Using a special speaker cord such as a litz wire, a coaxial
cable, or a cord which has the specified connecting
directionality may influence the sound quality.
Specifications
1
Press
2
Insert
3
Release
White
White
Black
Speaker terminals
on the amplifier
Black (
·
)
Red (
ª
)
Before connecting:
Twist and remove the insulation at the end
of each speaker cord.
Type:
2-way 3-speaker bass-reflex type
Magnetically-shielded type
Speakers
Woofer:
10.0 cm cone x 2
Tweeter:
4.0 cm cone x 1
Power handling capacity:
100 W
Impedance:
6
Ω
Frequency range:
55 Hz to 20 000 Hz
Sound pressure level:
85 dB/W•m
Dimensions (W x H x D):
250 mm x 1065.5 mm x 310 mm
Mass:
7.2 k
g
Design and specifications subject to change without notice.
Right
speaker
Left
speaker
SP-F508[UJ]f.p65
04.7.26, 4:10 PM
5
