(No.YA295)1-11
SECTION 3
DISASSEMBLY
3.1
DISASSEMBLY PROCEDURE
CAUTION AT DISASSEMBLY:
•
Be sure to perform the SYSTEM SETTEING, at the end of the procedure.
• Make sure that the power cord is disconnected from the outlet.
• Pay special attention not to break or damage the parts.
• When removing each board, remove the connectors as required. Taking notes of the connecting points (connector numbers)
makes service procedure manageable.
• Make sure that there is no bent or stain on the connectors before inserting, and firmly insert the connectors.
3.1.1 REMOVING THE STAND (Fig. 1)
(1) Remove the 2 screws
[A]
, then remove the STAND
COVER.
(2) Remove the 2 screws
[B]
and the 4 screws
[C]
, then
remove the STAND.
3.1.2 REMOVING THE REAR COVER (Fig. 1)
• Remove the STAND.
(1) Remove the power cord.
(2) Remove the 15 screws
[D]
, the 4 screws
[E]
and the 8
screws
[F]
, then remove the REAR COVER.
3.1.3 REMOVING THE CENTRE COVER (Fig. 1)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 7 screws
[G]
, then remove the CHASSIS
SHIELD COVER.
(2) Remove the 6 screws
[H]
, then remove the CENTRE
COVER.
3.1.4 REMOVING THE TERMINAL COVER (Fig. 1)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the CENTRE COVER.
(1) Remove the 7 screws
[J]
, the 6 screws
[K]
, and the 1
screw
[L]
, then remove the TERMINAL COVER.
