14
3
Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable
to the aerial socket on the wall and the
other end of the cable to the ANT socket
on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
Chapter
3
The first time you turn the TV on, it will go straight into the First Time
Installation menu. Most of the settings are pre-set so you can just press OK.
Please ensure the aerial is plugged in.
4. Press the
buttons to highlight your LANGUAGE then press OK.
5. Press the
buttons to highlight your COUNTRY then press OK.
6. Select Home Mode by pressing the OK button.
7. Press the buttons to highlight your desired picture mode. Its set to Natural
as this is the most energy efficient mode. Then press OK.
Do not connect the TV to the mains
supply until you have completed all the
connections.
HDMI3
HDMI 2
(ARC)
LAN
ANT
.
VGA
Optic.OUT
SPDIF
RF coaxial cable
(not included)
JVC 40' LED Smart 4K HDR TV LT-40C890 Manual.indd 14
07/12/2018 08:30