5
Important safety information
How to attach the stand
NOTE:
• Unplug the AC cord from the AC INPUT terminal.
• Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any
damage to the unit.
• Do not touch or press the TV-screen, glass might break under pressure.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1) Place the TV on its front onto a table.
2) Align the stand’s bottom-plate (supplied) as seen here.
It will fit in only one direction.
3) Hold the unit and attach the stand slowly. Finally secure the bottom-plate with 2 screws (included).
Dismantling the base
For wall mounting, the base must be dismantled. To do this, remove 3 screws (M, see page 10) from the
back. Take off the base entirely.
NOTE:
To detach the stand, perform these steps in reverse order.
•
Warning
(only for LT-32HG22J)
To prevent injury, which could be expec-
ted due to an eventual fall, the TV should
be fixed to the ground according to
instruction (see below).
Pull out 2 plates (see illustration). Fix to the appropriate ground with the supplied screws.
Note: There is no liability for any damage to the ground.
Important Instruction
For your own safety read following instruction carefully before attempting to connect this unit to the mains supply.
GREEN
&
YELLOW
(Earth)
(if there is earth cable)
FUSE
BROWN
(Live)
BLUE
(Neutral)
MAINS (AC) OPERATION
The wires in the mains lead are coloured in accordance with the following code :
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must be
connected to the terminal which is marked with the
letter E, or by the earth symbol, or coloured green or
green and yellow.
The wire which is coloured blue or black must be
connected to the terminal which is marked with the
letter N or coloured Black.
The wire which is coloured brown or red must be
connected to the terminal which is marked with the
letter L or coloured Red.
For continued protection against risk of fire,
replace only with same type and rating of fuse
(ASTA approved 5A 250VAC fuse).
IMPORTANT
3BQ1301A_EN.indd 5
3BQ1301A_EN.indd 5
8/25/10 2:17:21 PM
8/25/10 2:17:21 PM
