JVC KY-PZ200BE, Instructions Manual

Page: 21 / 52

Mounting the Camera to
the Ceiling Mount Bracket
0
Be sure to put on protective glasses to protect
your eyes from falling objects when mounting
the camera.
0
Be sure to place the base of the camera
horizontally. The camera will not operate
properly if it is slanted.
Memo :
0
The ceiling mount bracket is not necessary
when the camera is installed on a desktop or
attached to a tripod.
0
If necessary, make a hole (Φ40 mm) to route the
connection cable and fall prevention wire
(ceiling) into the ceiling.
Caution :
0
The fall prevention wire (for ceiling) is not
supplied. Make use of the wire while taking note
of its length, strength, pull and material
(insulation).
0
Attach the fall prevention wire (ceiling) to a place
with sufficient strength (ceiling slab, etc.).
0
Take note of the length, strength, pull and
material (insulation) of the fall prevention wire
(for ceiling) and use one with a wire strength of
150 N (15 k
g
) or more.
0
The inner diameter of the ring section of the fall
prevention wire (ceiling) mounted on the camera
should be above Φ3 mm but below Φ4 mm, the
outer diameter should be Φ9 mm and below, and
the thickness 2 mm and below.
0
The camera does not come with mounting
screws for attaching it to the ceiling. Make
appropriate use of the M5 expansion screws
(x4) according to the thickness of the ceiling.
1 Place the ceiling mounting bracket (ceiling
side) against the ceiling and mark the
mounting position on the ceiling
Memo :
0
Take note of the front direction of the camera
when placing the marks.
2 Drill holes into the ceiling at the marked
positions
Memo :
0
Insert a straw or toothpick into the mounting
holes to determine the depth and required
length of the screws.
3 Place the ceiling mounting bracket (ceiling
side) against the ceiling again at the
marked position
4 Fasten the mounting bracket using the M5
expansion screws (sold separately)
Memo :
0
Check that the screws are tighten securely when
mounting is completed.
.
Attaching Label to the
Camera
.
Before installing the camera to the ceiling, attach
the JVC logo label as illustrated in the diagram.
1 Peel off the label backing
2 Turn the label upside down
3 Align the center position of “V” of the JVC
logo on the camera with that on the label,
followed by attaching the label
Memo :
0
If there is dust or dirt on the surface, remove
accordingly before attaching the label.
0
Make sure that the JVC logo label is not tilted
when attaching.
Mounting the Camera to the Ceiling Mount Bracket
21
Installation/Connection