JVC KW-M27DBT, Instruction Manual

Page: 28 / 36

28
About this Unit
More information
Ñ
Playable Audio files
Audio format Bit rate/
(Bit count)
Sampling
frequency
MP3 (.mp3) 16 – 320kbps,
VBR 16 – 48 kHz
WMA (.wma) 16 – 320kbps 16 – 48 kHz
AAC-LC (.m4a, .aac) 16 – 320kbps 16 – 48 kHz
Linear PCM (WAVE)
(.wav) (16/24 bit) 8 – 192 kHz
FLAC (.flac) (16/24 bit) 8 – 192 kHz
Vorbis (.ogg) (16 bit) 8 – 192 kHz
• This unit can show ID3 Tag Version 1.0/1.1/2.2/2.3/2.4
(for MP3).
• The maximum number of characters:
– Tag : 70 characters
✎
NOTE
• WMA and AAC of which is covered with DRM cannot
be played.
• Although the audio files are complied with the
standards listed above, the play may be impossible
depending on the types or conditions of media or
device.
Ñ
Acceptable Video files
Video
format
Video codec Audio codec
MPEG-1
(.mpg, .mpeg) MPEG-1 MPEG Audio Layer 2
MPEG-2
(.mpg, .mpeg) MPEG-2 MPEG Audio Layer 2
MPEG-4
(.mp4, .avi) MPEG-4
(SP,ASP) MP3, AAC-LC (2ch)
H.264/MPEG-
4 AVC (.mp4,
mkv, avi, .flv,
.f4v, .ts) H.264/MPG-4
AVC
(BP/MP/HP) MP3, AAC (2ch)
MKV (.mkv) Video Format
follows H.264/
MPEG-4 AVC,
MPEG4, XVID MP3, AAC, Vorbis,
FLAC
Troubleshooting
What appears to be trouble is not always serious.
Check the following points before calling a service
center.
• For operations with the external components, refer
also to the instructions supplied with the adapters
used for the connections (as well as the instructions
supplied with the external components).
Ñ
General
No sound comes out of the speakers.
• Adjust the volume to the optimum level.
• Check the cords and connections.
The unit does not work at all.
• Reset the unit.
(P.2)
The remote controller does not work.
• Replace the battery.
Ñ
USB
While playing a track, sound is sometimes
interrupted.
• The tracks are not properly copied into the USB
device. Copy the tracks again, and try again.
Ñ iPod/iPhone
No sound comes out of the speakers.
• Disconnect the iPod/iPhone, then connect it again.
• Select another source, then reselect “iPod”.
The iPod/iPhone does not turn on or does not
work.
• Check the connecting cable and its connection.
• Update the firmware version of iPod/iPhone.
• Charge the battery of iPod/iPhone.
• Reset the iPod/iPhone.
Sound is distorted.
• Deactivate the equalizer either on this unit or the
iPod/iPhone.
A lot of noise is generated.
• Turn off (uncheck) “VoiceOver” on the iPod/iPhone.
For details, visit <http://www.apple.com>.
About this Unit