1-20
HX-Z1R
Fig.22
[Caution]
To reassemble the cylinder gear, etc.with the
cam unit (cam gear and cans R1/R2 assembly),
gear unit and drive unit, align the position of the
pawl "
x
" on the drive unit to that of the notch on
the cam gear "
q
". Then, make sure that the
gear unit is engaged by turning the cam gear
"
q
" (See Fig. 24).
Removing the cams R1/R2 assembly
and cam gear q(See Fig.22)
1.
2.
3.
4.
Remove the slit washer fixing the cams R1 and R2
assembly.
By removing the two pawls "
w
" fixing the cam R1,
separate R2 from R1.
Remove the slit washer fixing the cam gear "
q
".
Pull out the cam gear "
q
" from the C.G. base assembly.
Removing the C.G. base assembly
(See Fig.22 and 23)
Remove the three screws
J
retaining the C.G. base
assembly.
Fig.23
Slit washer
Pawl
Cam R2
Slit washer
Cam gear
q
Cam switch board
C.G. base assembly
Cam R1
Pawl
Cam gear
q
Notch
Cylinder
gear
Gear bracket
Cam R1, R2 assembly
Gear unit
Drive unit
x
Pawl
w
w
J
www.freeservicemanuals.info
3/29/2018
Digitized in Heiloo Netherlands